Sometimes one or more members of a switch stack fail to upgrade to the new version of the firmware. The Switch is upgraded to new firmware or IOS. Switch# Role Mac Address Priority H/W Version Current State Proceed with reload? ConfirmationĬheck the Firmware Version after the switch reloads to confirm and ensure the switch has booted up on new firmware. Private Config file : flash:/private-config.text edledge-switch# sh bootīOOT path-list : flash:/3.bin edledge-switch# conf tĮdledge-switch(config)# boot system switch all flash:/3.binĬheck system boot to ensure the new file is set up as a boot file as shown below. Set the boot system with the new image using the flash as shown below. Source filename ? 3.binĭestination filename ? We would need to upload the firmware into the flash of each member. Since the switch is in the stack and also it has 4 members. Now transfer the firmware file using the TFTP server from local storage to the switches. edledge-switch# conf tĮdledge-switch(config)# enable password edledge Do not forget to save the configuration when you set the enable password. It is not required if any other alternative mode of authentication is already configured. Set enable password if it is not set yet. It is always recommended and important to take back up the current running configuration before starting the firmware upgrade/downgrade to counter the situation if anything goes wrong. Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Sending 5, 100-byte ICMP Echos to 192.168.1.5, timeout is 2 seconds: Īccess the master switch and ensure the TFTP server and switch both can ping each other. Download the TFTP server using the link attached below if you do not have one. A TFTP server must be on the network and the switch software must be accessible to the TFTP server before attempting to download the switch software by TFTP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |